d_day_6
LDR Poseur!
I am replacing the plastic oil filler pipe (where the filler plug screws into on the left cylinder of my R1100GS) and it seem like it is taking a lot of pressure to pop the O ring that surrounds the small pipe down into the opening. I don't want to snap this thing a have plastic bits in my cyclinder, so if anyone has some words of wisdom I am all ears...
I know you have to align the small flange so it fits to the groove so the pipe doesn't spin with the filler cap when you open the plug. But it seems like you'd almost have to tap it with a small hammer, but that seems to ham handed to me.
Any suggestions would be appreciated.
Thanks.
I know you have to align the small flange so it fits to the groove so the pipe doesn't spin with the filler cap when you open the plug. But it seems like you'd almost have to tap it with a small hammer, but that seems to ham handed to me.
Any suggestions would be appreciated.
Thanks.