Just purchased a 98 K1200RS and dealing with a bum left knee. Does not like to bend and after about 20 minutes in the tucked position it begins to ache. I replaced the stock pegs with some old Triumph Tiger pegs which lowered it about 1.5 ". Added some seat height also. Neither of these was enough. Was wondering if there is any way wot attach highway pegs. I took off the belly pan plastic and see a threaded area on each side of the oil pan. See pic. Basically right where I would want to mount the pegs. Would need to fabricate something that would then stick out from belly pan on each side - through a hole I would need to figure out. Any thoughts?