twins4life
New member
I want to reset the TB's, clean the insides and clean the brass idle air screw. I dont want to reset the TPS because my Fluke 87 is 12 years old and I dont trust it to the mV range.
Proposed steps:
1. Remove and clean the TBs.
2. Remove and clean the brass screws, reinstall to 1.5 turns out.
3. Warm engine and set idle speed to 1100 and balance using BOTH of the throttle stop screws (not the brass screws at this point)
Any thoughts?
TIA
Proposed steps:
1. Remove and clean the TBs.
2. Remove and clean the brass screws, reinstall to 1.5 turns out.
3. Warm engine and set idle speed to 1100 and balance using BOTH of the throttle stop screws (not the brass screws at this point)
Any thoughts?
TIA