Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.
If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?
Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.
I am removing the heads from my '75 R90S for rebuilding. I do not plan to remove the jugs.
Because this will relieve the tension on the cylinder mounting bolts (rods), will I need to re-seal the cylinder base, re-seat pushrod oil seals, etc
Not an answer to your question, but considering the low cost involved I would pull the cylinders and replace the push rod seals and metal base gaskets.
For me, the driver would be to inspect the cam followers and have a look at the cam lobes, measure pistons, ring gaps and cylinder bores.