I have a Hex EzCan installed on my '15 R1200RT, with a Denali B6 Auxiliary LED License Plate Brake light attached. The brake light works great! I just purchased/received the following:
Denali Dr1 2.0 Light pods (not the full kit -- I have the EzCan)
Denali fairing mounts (under mirror mounts @ $99.95)
Denali 24" extension kits (2)
Question 1: The Denali Dr1's use a 3-wire connector, while the EzCan uses a 2-line plug. I know "Black to black", but which of the colored wires do I blank off on the included Denali pigtail?
Question 2: If the 24" extension won't reach from the fairing mount to the EzCan, could I use speaker wire to extend the "Denali to EzCan" pigtail?
I've searched the forum, the Twisted Throttle website, the Denali website, and the Hex website for answers to my question, to no avail.
Thanks for any help ya'll can provide!
Denali Dr1 2.0 Light pods (not the full kit -- I have the EzCan)
Denali fairing mounts (under mirror mounts @ $99.95)
Denali 24" extension kits (2)
Question 1: The Denali Dr1's use a 3-wire connector, while the EzCan uses a 2-line plug. I know "Black to black", but which of the colored wires do I blank off on the included Denali pigtail?
Question 2: If the 24" extension won't reach from the fairing mount to the EzCan, could I use speaker wire to extend the "Denali to EzCan" pigtail?
I've searched the forum, the Twisted Throttle website, the Denali website, and the Hex website for answers to my question, to no avail.
Thanks for any help ya'll can provide!