2018 R1200GS Rallye
Good Morning. I've having an issue and need a bit of help. In 2018 I installed the Hex ezCan to control my Weiser 2 in 1 turn signal and brake lights. The system worked flawlessly until just a couple of days ago when I noticed the rear brake lights were not working. Turn signals work, no problems. Front running lights work, no problem. Factory brake light works, no problem. Chased the wires, no problems. Used a jump wire and tested the Weiser brake light lead at the ezCan connector, no problem, lights work perfectly.
Plugged the ezCan in to my computer, updated the firmware and app. Tested the circuit in the diagnostic page in the app, brake lights worked. Thought all was good. Went to test to make sure the lights were working, got nothing but the factory brake light. So, went back into the app, tested the circuit and got nothing. So, either the ezCan isn't getting a signal from the bike or the ezCan isn't sending the signal to the lights. I suspect the ezCan, since the factory light is working.
I sent an email to Hex asking for help. Wondering, if any of you guys have any thoughts?
Thanks.
Ben
Good Morning. I've having an issue and need a bit of help. In 2018 I installed the Hex ezCan to control my Weiser 2 in 1 turn signal and brake lights. The system worked flawlessly until just a couple of days ago when I noticed the rear brake lights were not working. Turn signals work, no problems. Front running lights work, no problem. Factory brake light works, no problem. Chased the wires, no problems. Used a jump wire and tested the Weiser brake light lead at the ezCan connector, no problem, lights work perfectly.
Plugged the ezCan in to my computer, updated the firmware and app. Tested the circuit in the diagnostic page in the app, brake lights worked. Thought all was good. Went to test to make sure the lights were working, got nothing but the factory brake light. So, went back into the app, tested the circuit and got nothing. So, either the ezCan isn't getting a signal from the bike or the ezCan isn't sending the signal to the lights. I suspect the ezCan, since the factory light is working.
I sent an email to Hex asking for help. Wondering, if any of you guys have any thoughts?
Thanks.
Ben