TheRock58
TheRock58
Last week, the front headlamp burned out on my GSA. When I went to install a new bulb the plastic socket crumbled. I purchased a: https://www.repairconnector.com/products/H7-2-Pin-Headlight-Beam-Repair-Connector-Pigtail.html :a new H7 2 pin headlight pigtail with the hopes of removing the terminal connectors and plugging the original connectors in the new plastic socket. How do I carefully release these terminals?
If all else fails, I'll just solder the new pigtail in place. However, I'm sure I read where this has been done.
Thanks in advance,
If all else fails, I'll just solder the new pigtail in place. However, I'm sure I read where this has been done.
Thanks in advance,