landev
Member
Greetings,
I went on a 150 mile ride a couple of days ago and was having some Shift Assist up shift issues in gears 4-5, 5-6. It was intermittent, but happened 10 times or so. Other than that annoyance, the bike seemed to run quietly and smoothly. I have also experienced this Shift Assist issue on my 2015 GSWA... only rarely shifting up from 3-4. I did some reading last night and found recommendations to reset transmission to resolve the issue.
I just reset via a GS911 and went to do the "re-learning" step... running through the gears for 10 seconds each, up, then down. Doing so produced a horrible clunking noise (like funky U joint) so I stopped the procedure on second gear calibration and am wondering what to do at this point. It seemed that, in one of the posts I looked at last night, someone referred to a noise like this, but I can't find that post and don't recall and specifics.
Any ideas on this would be appreciated.
Thanks much in advance,
-l-
I went on a 150 mile ride a couple of days ago and was having some Shift Assist up shift issues in gears 4-5, 5-6. It was intermittent, but happened 10 times or so. Other than that annoyance, the bike seemed to run quietly and smoothly. I have also experienced this Shift Assist issue on my 2015 GSWA... only rarely shifting up from 3-4. I did some reading last night and found recommendations to reset transmission to resolve the issue.
I just reset via a GS911 and went to do the "re-learning" step... running through the gears for 10 seconds each, up, then down. Doing so produced a horrible clunking noise (like funky U joint) so I stopped the procedure on second gear calibration and am wondering what to do at this point. It seemed that, in one of the posts I looked at last night, someone referred to a noise like this, but I can't find that post and don't recall and specifics.
Any ideas on this would be appreciated.
Thanks much in advance,
-l-