Hi all,
I have had an Ezcan installed on my 2016GS for about two months now, and as of a few days ago, it was working great. However, suddenly my auxiliary lights have stopped working. After re-examining connections and trying to reset the software, this is what I have found:
If I use the setup software and plug the USB cable to the device, the lights work again. However, as soon as I unplug the USB, the lights go off. I also notice that the little green light on the device goes out. Should that light be on even when not connected to the software?
It seems like the device is not holding the configuration information when not connected to the PC and configuration software. I'm thinking that perhaps it's only getting power from the USB connection and not the battery, but all other electrical functions on the bike work fine. Has anyone run into this before? Am I missing something simple?
Thanks,
Dan
I have had an Ezcan installed on my 2016GS for about two months now, and as of a few days ago, it was working great. However, suddenly my auxiliary lights have stopped working. After re-examining connections and trying to reset the software, this is what I have found:
If I use the setup software and plug the USB cable to the device, the lights work again. However, as soon as I unplug the USB, the lights go off. I also notice that the little green light on the device goes out. Should that light be on even when not connected to the software?
It seems like the device is not holding the configuration information when not connected to the PC and configuration software. I'm thinking that perhaps it's only getting power from the USB connection and not the battery, but all other electrical functions on the bike work fine. Has anyone run into this before? Am I missing something simple?
Thanks,
Dan