While removing tupperware around my 2014RTW bike to hook up a new power supply for my tank bag, i noticed that the a vacuum connection was not installed going to my right cylinder inlet connection on the rubber boot and the tabs were broken off the left side tupperware. The last service the bike had seen was during the 6k service interval where they had to remove the engine to fix a leaking gasket. So it would seem that whenever i drop off the bike for maintenance, I would need to go over everything with a fine tooth comb to verify they did not forget to tighten something or reinstall connections. I am so sick of this lack of attention to detail. I know the techs have a hectic job in servicing all these wonderful bikes but whatever happened to self checking and verification and ensuring the bike is good to go! OK, done ranting, but i guess i am talking myself into doing all the maintenance myself as I am the only one with a personal relationship with it....