Inner paralever bolt 30mm socket(cut-out) for torquing paralever 03 K1200RS

[bubbadozer1]

I’m looking for a 30mm deep socket (1/2 in drive) that has cutout for torquing the inner paralever bolt. I know BMW sells one, but it’s cost prohibitive. It’s so I can put a Allen key in the I berboktamd keep it from moving after it’s been torqued and to allow the outer nut to be torqued.

Any ideas are much appreciated.

 

[spoon]

Laser Tools 4740

Look on ebay for Laser Tools 4740 - Swinging Arm Bearing Tool. $21.69/each

 

[henzilla]

Some of us loctite the pin and set it in position. Let threadlocker set up, mark w/sharpy and install and torque nut....have yet to see the pin move with this method

 

[bubbadozer1]

Thanks henzilla!