tgf429
Plasterman
OK, not the smartest thing I've done but my rear pads on my 2009RT have worn down to the metal and have made some minor grooves in the rear rotor. Do I need to replace it, can it be turned on a lathe or should I just replace the pads and call it good?
Never thought the pads would be shot a 15000 miles and was not paying close enough attention
If I was to replace the rotor, is there an aftermarket rotor that is an improvement from the factory rotor?
What are good pads to use for replacement both front and rear?
Thanks
Tom
Never thought the pads would be shot a 15000 miles and was not paying close enough attention
If I was to replace the rotor, is there an aftermarket rotor that is an improvement from the factory rotor?
What are good pads to use for replacement both front and rear?
Thanks
Tom