k1200sbeast
New member
Hello everyone fellow BMW motorcycle owners I am proud to be one now myself. Hate to start out after my joining this wonderful group asking a silly question but I am stumped I followed the factory guidelines and bulletin about bleeding the clutch through the bleeder screw on my 08 k1200s drop the bike a few weeks ago and broke the clutch line at the slave cylinder. I have replaced the line with an aftermarket line I think is going to suffice due to lack of funds to get the OEM part which I would have preferred. At any rate I have replaced the line and follow the bleed line instructions as per factory I will try to attach it going through the bleeder screw using a syringe pushing the fluid back feeling it until the reservoir is full I have struck the reservoir out about four or five times and still feel the reservoir still no clutch lever all spongy not any kind of pressure made sure I had to travel right on the clutch lever it's getting enough free travel and it's I assume pushing the rod all the way in any suggestions.? I thought I was good when I saw fluid in the reservoir of the first time but I have pulled the fluid out and pushed more in and filled the reservoir again three or four times. If anyone has any suggestions I would greatly appreciate it...