scootrp125x
They call me Gort
I am replacing my starter today, what a pain but first time projects usually are. I am ready to bolt on the new starter but I noticed that the new starter does not seem to mate flush to the engine case, especially where the pin protrudes from the engine case. It's very close but I seem to recall the old one mated flush against the case on the left side that I could see as I was unbolting the old one. Can anyone tell me if this is a concern? I see there are no gaskets between the starter and the case so it appears that this are does not have to be 100% sealed.
Thanks. Mark
Thanks. Mark