LCampbell
New member
I have a vintage racing sidecar that is powered by a BMW 750 twin. The heads are dual plugged but I am only using one set of plugs with the points in a can ignition. I want to get the second set of plugs working & I am thinking of using the BMW 81 & on electronic ignition. I think the ignition sensor (canister) will fit in the same location as the points in the can do. I think I need to use the Dyna 1.5 Ohm coils (brown) with wire type plug wires & 5.0K ohm resistor caps. Is this doable?
The part # on the ignition control unit I have is 12 14 1 244 477 (It came out of a 91 R100GS) & doesn't match the part # in the latest parts fische. Is this an old part number?
Are there any sketches or wiring diagrams on hooking up the wiring to the dual plug setup?
Any help would be greatly appreciated.
The part # on the ignition control unit I have is 12 14 1 244 477 (It came out of a 91 R100GS) & doesn't match the part # in the latest parts fische. Is this an old part number?
Are there any sketches or wiring diagrams on hooking up the wiring to the dual plug setup?
Any help would be greatly appreciated.