I have Revit waterproof boots purchased some 8 years ago. Problem: boot toe section rubber is too thick to adequately feel the gear selector. As a result, I will sometimes shift before the clutch is engaged. So I have been wearing a pair of work boots that allows me to "feel/sense" the shifter.
Few stores have a wide range of boots to adequately test out. Therefore, one is left to assessing which ones might be appropriate when choosing on-line, such as Cycle Gear on the West coast. They are willing to have models shipped, but they may not appropriate & then try again.
Any comments on boot brands/models with waterproof/semi-waterproof ability that have toe portion sensitivity?? Thanks very much.
Few stores have a wide range of boots to adequately test out. Therefore, one is left to assessing which ones might be appropriate when choosing on-line, such as Cycle Gear on the West coast. They are willing to have models shipped, but they may not appropriate & then try again.
Any comments on boot brands/models with waterproof/semi-waterproof ability that have toe portion sensitivity?? Thanks very much.