mikewillison
New member
1998 R1100GS (52,000 km)
I replaced the rear main seal 20,000 km's & 4 years ago.
But I always had some oil seepage between the cases on the right hand side.
So in I go again.
The gearbox input seal is dry.
The rear main seal looks good. But!
The bolt (red circle) comes right through the casing.
The oil is radiating out from around it.
I suspect that engine oil is following the threads right into the clutch housing.
My plan is to JB weld over it.
Anyone seen this before?
Any other thoughts on repair?
Thanks
I replaced the rear main seal 20,000 km's & 4 years ago.
But I always had some oil seepage between the cases on the right hand side.
So in I go again.
The gearbox input seal is dry.
The rear main seal looks good. But!
The bolt (red circle) comes right through the casing.
The oil is radiating out from around it.
I suspect that engine oil is following the threads right into the clutch housing.
My plan is to JB weld over it.
Anyone seen this before?
Any other thoughts on repair?
Thanks