Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.
If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?
Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.
I had Apple Hydraulics re-sleeve the original master cylinder on my '74 R90s and it came out great.
With 150k, my last rebuild (new piston and seal) was still allowing a drip or two of brake fluid in the rubber catch boot, so I took advantage of their re-sleeving service.
Got it back, bench...
Thanks to Lee 98 I rehabbed my leaking master cylinder. I'll share a few photos but first a short narrative.
Only issue I had was separating the master cylinder from the bike after removing all the screws necessary because it had stuck from crud and had to be tapped apart. The piston was in...
Last Fall I installed a set of ROX risers & a longer front brake line. I left the brake reservoir empty with a clean paper rag stuffed in it & covered the bike for the winter. Now attempting to ready the bike for a much anticipated riding season, I can't get the air out of the system. I have...
Two years ago I moved my 1974 /6 from Phoenix where it was dry and warm to Iowa where it is cold and wet. All winder it sat in a damp garage, and this spring, upon starting it up, I noticed that the front brake lever would squeeze all the way to the grip. I then noticed that there was a pool...
Any advice or help on rebuilding the brake master cylinder on my 78 R100/7? I ordered the kit, should be here today, for the 14mm cylinder (I have a single brake rotor).
Any videos/articles out there?
What should i NOT do?
Thanks in advance.
Greetings all... i recently noticed my master cylinder leaking from the piston, the worst part is i just repainted the frame and cleaned all the rust that had built over the years under the master cylinder. the issue i have is wether or not to try n rebuild the piston or replace the whole thing...