• Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.

    If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?

  • Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.

    The Election forum is here: Election Forum

handlebar

  1. H

    Difficulty removing brake cable from brake lever (R75/5)

    Hello fellow MOA'ers, I am currently changing the handlebar over to a low bar. Currently, I am at the step removing the front brake lever. I am having difficulty releasing the cable from the brake lever. I have taken out the pivoting screw, and the tension screw is already turned all the way...
    • htwashere
    • Thread
    • airhead brake cable removal handlebar r75/5 rebuild
    • Replies: 4
    • Forum: Airheads
  2. apuesto

    Handlebar replacement help

    Hi folks. I'm planning on replacing the handlebar on my K1600B with one with more pullback and rize due to issues I have with my back. I'm going to need to extend all the cabling and the brake and clutch lines. Has anybody extended any of these cables? Am I going need to "cut and extend"? Are...
  3. C

    Routing wires for heated grips on 2004 R850R - help needed

    Hi, First time poster and New member so be gentle! :) I have a 2004 R850R that came without heated grips. As luck would have it I found a useable right hand side combination switch and two functioning heated grips on Ebay which I purchased. Replacing the combination switch would be rather...
  4. M

    '09 GSA 1200 - Handlebar help - Tall Guy help

    Hi all - I am 6'6" and am in need of some help. My bike has bar-risers but I need a little more to truly stand comfortably off road. My preference is to replace the stock bars with a higher rise. I know the bar is 1 1/8" in the middle and a width of 950mm. What I can not determine is the...
  5. M

    Can i double up the bar risers? 2012 R1200RT

    Short guy with...short arms. 2012 R1200rt Purchased helibar risers which really help. But... I really want max satisfaction which = sitting just a little more upright. Can I: Double up the risers for twice as much up and back effect? Seems plausible as the whole pattern is ready for it...
    • mule
    • Thread
    • bar riser handlebar handlebar riser handlebars helibars
    • Replies: 16
    • Forum: Hexheads/Camheads
  6. B

    R90S Brake Lever

    This may be a very simple question, but after looking at the handlebar brake lever on the R90S, I'm not sure how to access the lever to remove it and replace it with a new lever. It's a '75 model.
    • BobraWilbanks
    • Thread
    • brake lever handlebar r90s removal
    • Replies: 4
    • Forum: Airheads
Back
Top