Page 2 of 2 FirstFirst 1 2
Results 16 to 16 of 16

Thread: F-Twins Tech F650/700/800 - Rear Wheel Removal and Install

  1. #16
    Registered User drneo66's Avatar
    Join Date
    Jun 2009
    Location
    Rochester, MN
    Posts
    1,146
    Install the speed/ABS sensor back into the housing on the rear wheel, using your T25 star (Torx) bit - torque is 8 Newton meters (70.81 inch pounds or 5.9 foot pounds). Route the wire up as it was before.


    Take a moment to pump the rear brake pedal several times in short strokes, this will seat the pads against the rear disc. If you had the tire replaced, maybe you'd like to check the air pressure in the tire so it's at the desired level.

    Finally, double check all your work and then ride off into the sunset!
    Last edited by drneo66; 04-06-2022 at 11:36 PM.
    Current: 2007 BMW R1200RT, 2013 F800GS
    Former: 1995 BMW K75S, 2009 BMW G650GS
    MOA Member #:150400, IBA#: 37558

Similar Threads

  1. F-Twins Tech F650/700/800 - Engine Oil Level Check
    By drneo66 in forum F-Twins DIY/Tech Library
    Replies: 3
    Last Post: 03-07-2021, 05:20 PM
  2. F-Twins Tech F650/700/800 - Battery Removal
    By drneo66 in forum F-Twins DIY/Tech Library
    Replies: 7
    Last Post: 01-17-2021, 02:16 PM
  3. F-Twins Tech F650/700/800 - Engine Oil Change with Filter
    By drneo66 in forum F-Twins DIY/Tech Library
    Replies: 11
    Last Post: 12-04-2020, 11:59 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •