Does anyone know if someone is rebuilding drive shafts for my bike. The u joint end is messed up.
Does anyone know if someone is rebuilding drive shafts for my bike. The u joint end is messed up.
Welcome to the forum! Possibly some ideas and/or reading is in these threads:
https://forums.bmwmoa.org/showthread...-joint-rebuild
https://forums.bmwmoa.org/showthread...ailure-R1200RT
https://forums.bmwmoa.org/showthread...riveshaft-fail
Hopefully some current owners will be by to help out.
If some time goes by with not much visibility, then one of the moderators can move this to the Wethead forum.
Kurt -- Forum Liaison ---> Resources and Links Thread <---
'78 R100/7 & '69 R69S & '52 R25/2
mine-ineye-deatheah-pielayah-jooa-kalayus. oolah-minane-hay-meeriah-kal-oyus-algay-a-thaykin', buddy!
ADVRider thread on R1200LC Driveshaft issues and U-joint Failures - over 1500 entries
My '14 Rear U-Joint developed a sticky spot on one phase at 48,000 miles, I replaced my driveshaft.
The OEM U-Joint is "Not serviceable" however that joint is available https://www.drive-lines.com/elbe/tem...ies=ELBE%20106
This ADVRider thread details U-Joint Replacement and shaft alignment https://advrider.com/f/threads/05-dr...#post-18086826
There is a company in Michigan that rebuilds driveshafts for LC bikes with mixed results reported.
Ted Porter/The Beemer Shop does not offer a driveshaft for LC bikes yet, they do offer replacement shafts for earlier models.
The only dumb question is the unasked question - Anonymous
Eat every Ham Sandwich like it is your last Ham Sandwich! - Anonymous
Posting Permissions
Reply With Quote