• Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.

    If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?

  • Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.

    The Election forum is here: Election Forum

My 1999 K1200LT won't start

djcondie

Member
As I was backing out of my garage my 1999 K1200LT died and won't start. I have had no problems before this. It turns over fine. I just just replaced the fuel filter, started the bike and it ran fine. Does anyone know how to check to see if the fuel pump is working? Any other ideas what might be wrong? Thanks, Dave
 
Dave,

9 times out of 10, when a bike fails right after when you have just worked on it, what ever you just did is the problem.

Usually,when someone JUST replaced the fuel filter and the bike quits shortly after, they find that the filter hose has blown off inside the tank.

I am not intimately familiar with the K1200 bikes, but I do know that there is quite a bit of tupperware removal involved to do ANYTHING on those bikes. It MIGHT be quicker to check the fuel pressure at the quick disconnects than removing the pump and filter (I don't know, but someone else might chip in).:dunno




:dance:dance:dance
 
Thanks for the reply. I have been thinking it has to do with the work I did. I was just hoping that someone would have an idea that would keep me from taking off all that plastic again.
 
The only advice I have is do not put the plastic back on until you are entirely satisfied that you have found the problem and fixed it. Test ride away, without plastic, until you are sure.
 
I just had a similar issue on my K1100LT, it ended up being that I replaced the internal fuel tank hose with the wrong hose and it came off internally in the tank because the hose wasn't rated for in-tank use. I know yours has a different setup, more like my K1200GT, I would be going back in their, almost guaranteed it's either a mechanical issue with the hoses.

Did you check that the electrical connector to the pump is fully seated? You could always try disconnecting and reconnecting. You could also take a quick voltage check of the pins on the bike side and do a resistance check on the tank side.

Shouldn't be hard to figure out.
 
Thank you all for the replies. I'm feeling that a hose has come off inside the tank. I will find out this weekend.
 
Back
Top