I have a 2019 R1250RT. I installed Skene lights with the turn signal and decelerator module. After the install I turned on the ignition and tested the lights. Everything worked as it is supposed to. I started the bike and it ran for about two seconds and then shut down. I turned off the power and then turned it back on, now the skene lights do not turn on but the bikes brake light,taillight and turn signals all work. I completely disconnected the Skene lights and tried to start the bike but it still wont start. Everything comes on and you can hear the fuel pump run but the bike cranks and will not start. Anyone have any idea what is going on here. Thanks for any help in advance.
-
Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password. If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?
-
Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.
The Election forum is here: Election Forum
skene p3 lights problem
- Thread starter 44135
- Start date
glenfiddich
TravelsWithBarley.com
Give Jerry Skene a call. He knows his products inside and out and is a master at troubleshooting advice.
