Page 3 of 3 FirstFirst 1 2 3
Results 31 to 32 of 32

Thread: Broken Tabs

  1. #31
    Quote Originally Posted by PoorUB View Post
    I spit on the pegs before I put the panel back on!
    I use grease.
    Paul Glaves - "Big Bend", Texas U.S.A
    "The greatest challenge to any thinker is stating the problem in a way that will allow a solution." - Bertrand Russell
    http://web.bigbend.net/~glaves/

  2. #32
    Old Rider - OK Mechanic 105258's Avatar
    Join Date
    Mar 2004
    Location
    Teulon Manitoba Canada
    Posts
    219

    Gromets

    Quote Originally Posted by PGlaves View Post
    After the piece holding the grommet is reattached - before engaging whatever sticks in the grommet - reduce the diameter. I dislike the system of these "mushroom" things stuffed into those grommets even when the grommets are in a hole in a steel piece welded to the frame. So on my K75s and R1150 and others, I always sand down the male portion to make it smoother, smaller, and easier to insert and remove.
    I like to put a little silicone or dielectric grease on these grommets ease the slid in process. A very small electrical ties wrapped through the center of the grommet will keep the grommet in place.
    David Nicholls
    Teulon Manitoba - Canada

    2015 R1200GSA-LC

Similar Threads

  1. 2003 K1200GT - What glue to repair tabs?
    By jrmull in forum Flying Brick K-bikes
    Replies: 15
    Last Post: 11-07-2019, 10:05 PM
  2. Front fender tabs
    By cschmidt in forum Wetheads
    Replies: 3
    Last Post: 05-08-2018, 12:04 AM
  3. Side cover tabs on R100RS
    By windancer in forum Airheads
    Replies: 3
    Last Post: 01-14-2013, 11:34 PM
  4. Replies: 6
    Last Post: 05-29-2009, 01:26 PM
  5. Corkscrewed centre stand tabs
    By TonysR100 in forum Airheads
    Replies: 11
    Last Post: 03-03-2009, 10:58 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •