I recently had the ABS module repaired by ModuleMasters, but I am flummoxed by the reinstall process. The module is an iABS2, also referred to as ABS IV , I think. It has no bleed nipples on the module itself. I bought the GS-911 unit so I could run the process that bleeds the module, but the instructions advise to do a 'conventional bleed' first, and I can't even get that process started! I can't get any fluid to flow in either the front or the rear circuits. Do I need to apply vacuum to the caliper nipples to fill the system? Could that damage the newly repaired ABS module? ANY HELP WOULD BE GREATLY APPRECIATED. The nearest dealer is about 150 miles away. Thanks!