Innovv k2 wiring help

hewness · Nov 3, 2019

I'm an "electrical" novice and would really appreciate some pro advice for installation. In addition to usual red/black to red/black, the yellow wire must connect to a switched device/circuit, so the unit knows when the bike is on/off. On a 2018 GSA, how would I go about this without blowing up the neighborhood? Thank you.

Hugh

bicyclenut · Nov 3, 2019

Without adding something like a Hex EZCan or addition fuse block, etc. probably best to go off the license plate light or taillamp light as these would turn on with ignition on. Probably also located in area under seat where you would be placing the DVR.

The Innovv has a relay box that switches the system on and draws power from the bike when it detects power from the yellow wire, it doesn’t use power from this but uses it to turn on relay.

Sent from my iPhone using Tapatalk

Omega Man · Nov 3, 2019

Welcome to the forum!
I like the parking light concept. Here a thread with some info-

https://forums.bmwmoa.org/showthrea...ched-hot-wire-to-trigger-relay-for-fuse-block

Good luck.

Gary

PoorUB · Nov 3, 2019

If you have Powerlet sockets they are on with power up and off a few seconds after the bike is shut down.

crna59 · Nov 3, 2019

I bought a Canbus connector that I could connect directly to. Works like a charm!!

hewness · Nov 9, 2019

Thanks all. Reminder that all the lights on the 2018 GSA are LED. Motorrad tech determined that getting enough bang to trigger the K2 requires patching into the fuse for an LED - in this case the headlight fuse. So far the K2 and bike are all happy, and so am I.

Innovv k2 wiring help

hewness

New member

bicyclenut

Member

Omega Man

Fortis Fortuna Adiuvat

PoorUB

Active member

crna59

Member

hewness

New member

Similar threads

Forum statistics

Share this page