• Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.

    If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?

  • Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.

    The Election forum is here: Election Forum

Signal lamp question

B

billdor

New member
I am installing a safe turn system (STS) on my 2006 R1150R which will self cancel my signal lights when I forget which is almost always. I have been trying to find a wiring schematic for this bike so that I can get the correct wire colors and ensure a correct installation and to help find a location to best access all of the wires.
The only schematic I have found so far is so small that I can not read the fine print for the colors and it does not seem to be for the right bike as it only shows one switch for both indicators instead of separate left and right switches as on my bike.
Any help would be appreciated.

Bill
 
billdor said:
I am installing a safe turn system (STS) on my 2006 R1150R which will self cancel my signal lights when I forget which is almost always. I have been trying to find a wiring schematic for this bike so that I can get the correct wire colors and ensure a correct installation and to help find a location to best access all of the wires.
The only schematic I have found so far is so small that I can not read the fine print for the colors and it does not seem to be for the right bike as it only shows one switch for both indicators instead of separate left and right switches as on my bike.
Any help would be appreciated.

Bill
Click to expand...

Bill,

Have you considered a plug and play system like that offered by Kisan? No wiring necessary. Just replace your factory relay with the Kisan unit. Here’s the part for your bike. https://kisantech.com/signalminder.html?find=bmw-r-bikes-r1150r--r28--2006-511?amfinder



Sent from my iPad using Tapatalk
 
tangoalpha said:
Bill,

Have you considered a plug and play system like that offered by Kisan? No wiring necessary. Just replace your factory relay with the Kisan unit. Here’s the part for your bike. https://kisantech.com/signalminder.html?find=bmw-r-bikes-r1150r--r28--2006-511?amfinder



Sent from my iPad using Tapatalk
Click to expand...

Thanks TA but I have already purchased the STS system. I think you are right in that it would be a lot easier to install and I may yet go with ut if I can not make the STS work.

Bill
 
You must log in or register to reply here.

Similar threads

P
Purpose of new Switch on ‘98 R1100RT Right Hand Control?
Replies
7
Views
1K
senseamidmadness
senseamidmadness
P
Replacing LED turn signals on 2004 R1150R
Replies
3
Views
1K
gsaddict
gsaddict
M
White/Clear front turn signal lens
Replies
10
Views
1K
pauls1150
pauls1150
T
Turn Signal Oddity
Replies
3
Views
956
RPGR90s
RPGR90s
W
Finding high beam wire (under fuel tank?) on 1993 R100RT
Replies
10
Views
958
wybeemer
W
Back
Top