Results 1 to 2 of 2

Thread: Exhaust-Tire clearance

  1. #1

    Exhaust-Tire clearance

    I've got a "new to me" 2008 K12GT. When I bought it the muffler was about a 1/4" from the rear tire and there were marks on the exhaust from the tire. I loosened the exhaust clamp, adjusted the gap between the tire and muffler and clamp to 1.5". After a few hundred miles the gap is less. I've done this twice. This can't be normal. Anyone ever see anything like this?

    K12GT_Exhaust_Tire.jpg

  2. #2
    not so retired henzilla's Avatar
    Join Date
    Sep 2006
    Location
    CENTEX USA
    Posts
    10,268
    Welcome to the forum

    There are a few models that mention the clearance in the owners manual. It can rotate at clamp between can and header. No biggie, just check when reinstalling or when checking air pressure.

    My RT and K12S could close the gap if the collar band was not tight or not paying attention when bolting the can back in place. The gap should be closer to an inch without looking at a manual. You look good to go.
    Steve Henson-Mod Team and SABMWRA Prez

    Be decisive, right or wrong.The road of life is paved with
    flat squirrels who couldn't make a decision~unknown

Similar Threads

  1. Replies: 8
    Last Post: 04-18-2015, 03:50 PM
  2. Exhaust valve clearance issue '88 K100LT
    By LSkrabut in forum Flying Brick K-bikes
    Replies: 7
    Last Post: 03-21-2011, 02:55 AM
  3. Valve Clearance
    By sumran in forum Airheads
    Replies: 20
    Last Post: 02-27-2008, 02:08 AM
  4. Caliper clearance
    By Boof39 in forum Flying Brick K-bikes
    Replies: 2
    Last Post: 07-17-2007, 10:38 AM
  5. K valve clearance
    By pmdave in forum Flying Brick K-bikes
    Replies: 7
    Last Post: 11-06-2003, 01:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •