I'm replacing the gaskets on the cylinders and the push rod seals, etc. I ordered all the parts and noticed in my Clymers' manual that there a gasket at the connection point of the engine block and the cylinder head in the manual (in addition to the rubber gasket)? I don't, however, see it on the Fiche.
Picture attached and the paper gasket I’m looking for should fit between the cylinder head and the engine block. Anyone know if this is a mistake in Clymers or if Fiche just doesn't show it?
Picture attached and the paper gasket I’m looking for should fit between the cylinder head and the engine block. Anyone know if this is a mistake in Clymers or if Fiche just doesn't show it?