Results 1 to 4 of 4

Thread: 2003 K1200GT - Rear brake pads change - pin without retainer clip style

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Registered User
    Join Date
    Aug 2018
    Location
    Bolingbrook, IL
    Posts
    155

    2003 K1200GT - Rear brake pads change - pin without retainer clip style

    I changed the rear brake pads for the first time. Good experience and all said, but I should have just left them alone. The other pads were good enough just as the dealer told me.

    Well, being a skeptic and given a rainy day, something has to be taken apart.

    It started youtube videos. A couple found LT and and RS version, not exactly my brake but the concept was ok. Printed out the torque numbers 24Nm, I has referenced. I got a wire ready for hanging the caliper from the frame. Soapy water ready to clean the brake dust. I pulled the side panel off, moved the coolant tank to get into the brake reservoir. Pulled some out some brake fluid to avoid overflow compressing the pistons.

    Picture 1 shows first problem. I couldn't get the caliper out because it hit the wheel. Not enough room. I wasn't about to remove the wheel. Quitting was preferred. More rain and thunder outside. An idea hit....get them from the top.

    Picture 2, second problem was removing the plastic cover and for the life of me could not find a retaining clip on those pins. Not front, not back. Nowhere. Quitting again was preferred.

    When all else fails use a hammer. Surprisingly, one of the pins moved out hitting from the back. I saw the U shaped retaining clip and assumed I broke it off inside. Well once I create a problem, more hammering is the solution. The other pin might as well match. That second pin came out. I figured I sheared off both clips.

    A couple other parts went flying, but I had a picture before hand and not too complicated to know where they went.

    Soapy water to wash out the dust. Pistons pushed in with hand pressure. Brake grease probably not needed, but available and used. New pads back in, and pins put back after cleaning. As for the U shaped retaining clips, I guess that is the new style I hadn't seen on videos. The plastic cap seems to also retain the pins from sliding out.

    Final pictures, show that I should have left them alone. Pads had plenty of life.

    This post is just incase you run into the non-clip pins. The plastic cover must keep them in place.

    Live on the wild side.
    Attached Images Attached Images
    2003 K1200GT

Similar Threads

  1. 2003 K1200GT - any tips on fuel filter change?
    By jrmull in forum Flying Brick K-bikes
    Replies: 50
    Last Post: 03-25-2019, 04:55 AM
  2. 2003 K1200GT - Final Drive oil change
    By jrmull in forum Flying Brick K-bikes
    Replies: 4
    Last Post: 12-11-2018, 06:01 AM
  3. Rear Brake Anti-Rattle Clip???
    By bobr9 in forum Oilheads
    Replies: 7
    Last Post: 03-16-2014, 10:26 PM
  4. Bing Jet needle clip retainer 78' R100/7
    By godfather in forum Airheads
    Replies: 5
    Last Post: 12-11-2013, 04:27 PM
  5. Oil Change Question K1200GT 2003
    By VTRider500 in forum Flying Brick K-bikes
    Replies: 6
    Last Post: 08-18-2009, 05:20 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •