U-shaped tool doesn't remove radio '97 K1100LT

New to me '97 K1100LT.
I have the radio working after entering the code. Only one of four speakers works having adjusted both balance knobs. I'm trying to remove the radio to look at the connection or reseat to see if there's anything to help get the other speakers functional.
I can't seen to release the radio with the U-shaped tools. I slide them in until I hear a 'click', no luck. I continue to slide them down, no luck. I push as hard as I can and seat the tools to the very bottom, no luck. Any tips?

Have fun,
Jer

Jer,


I have no direct knowledge of this, but I believe the wire tools just release the tabs that hold the radio in. You must pull on the body of the radio to get it out.

98lee said:

Jer,


I have no direct knowledge of this, but I believe the wire tools just release the tabs that hold the radio in. You must pull on the body of the radio to get it out.

Click to expand...

Yep, that's how I understand it, too. No luck. It stays FIRMLY in place.

Thanks,
Jer

Been a long time since I've had a big K, but do you also need to squeeze the "legs" together as you pull, to release a little catch at the bottom...?
Shine a small bright flashlight down there and scrutinize.