• Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.

    If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?

  • Beginning April 1st, and running through April 30th, there is a new 2024 BMW MOA Election discussion area within The Club section of the forum. Within this forum area is also a sticky post that provides the ground rules for participating in the Election forum area. Also, the candidates statements are provided. Please read before joining the conversation, because the rules are very specific to maintain civility.

    The Election forum is here: Election Forum

Skene lights install issue

donng

New member
Hello all perhaps someone here has experienced this and can offer a solution

I’ve installed the P3 lights but there’s an issue with one turn signal

As set up on the bike both the left and right LED will flash with brakes
but the right led will not flash with the right turn signal

The left bike turn signal and led works
The right side of the bike only the bike turn signal works but not the LED

Both LEDs do the normal Flickr and both LEDs work with the brake light

My bike is a 2005 BMW K1200S
 

Attachments

  • 0019F188-2E2C-4595-89D4-FD41BE377091.jpg
    0019F188-2E2C-4595-89D4-FD41BE377091.jpg
    342.6 KB · Views: 112
Your Skene controller is not tapped into the correct wire or the controller has a malfunction. Those are the only two options.

Check your posi-tap to make sure you have the end with the sharp needle in it poking into the correct wire so that the turn signal wire is actually tapped and not just dented.
 
Back
Top