Results 1 to 4 of 4

Thread: Clutch handlebar assembly

  1. #1
    Registered User Motodan's Avatar
    Join Date
    Dec 2007
    Location
    Indiana
    Posts
    2,222

    Clutch handlebar assembly

    This is on a 2008 R12RT. Want to rotate clutch/switch assembly on handlebar, assume pinch bolt head is inside switch housing. If that is the case, are there just two screws to remove when splitting housing?
    2018 RT
    MOA #46783

  2. #2
    Registered User Motodan's Avatar
    Join Date
    Dec 2007
    Location
    Indiana
    Posts
    2,222
    155 views...no input, let me try this again. Has anyone ever rotated (or removed) the clutch side gear switch on a 2005 to 2009 R1200RT? If so, how did you loosen the assembly to rotate it? Trying to get clutch lever adjusted upward.
    2018 RT
    MOA #46783

  3. #3
    not so retired henzilla's Avatar
    Join Date
    Sep 2006
    Location
    CENTEX USA
    Posts
    9,825
    I was going to try and recall the locations, and actually did one yesterday.

    One small Phillips self tapping screw in the mirror hole well, one silver Phillips oval head under pod near blinker button and the out in the open one on the front

    May have to wiggle it to allow it to come apart and the bar clamp is obvious at that point
    Steve Henson-Mod Team and club tire changer

    Be decisive, right or wrong.The road of life is paved with
    flat squirrels who couldn't make a decision~unknown

  4. #4
    Registered User Motodan's Avatar
    Join Date
    Dec 2007
    Location
    Indiana
    Posts
    2,222
    Quote Originally Posted by henzilla View Post
    I was going to try and recall the locations, and actually did one yesterday.

    One small Phillips self tapping screw in the mirror hole well, one silver Phillips oval head under pod near blinker button and the out in the open one on the front

    May have to wiggle it to allow it to come apart and the bar clamp is obvious at that point


    Thank you...no doubt, silver one is the culprit here. To the garage I go.
    2018 RT
    MOA #46783

Similar Threads

  1. Clutch assembly
    By DAVIS2X1 in forum F-Twins
    Replies: 1
    Last Post: 10-11-2015, 03:17 PM
  2. 1992 K75S with ABS - Handlebar / dash pad assembly
    By heejrbmw in forum Flying Brick K-bikes
    Replies: 6
    Last Post: 10-29-2013, 05:04 PM
  3. Clutch Assembly Question
    By barron_williams in forum Airheads
    Replies: 6
    Last Post: 03-13-2012, 12:17 AM
  4. Replies: 4
    Last Post: 12-19-2011, 04:09 PM
  5. Clutch assembly question?
    By PETDOC in forum Oilheads
    Replies: 0
    Last Post: 07-31-2007, 11:32 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •