The riser on my R90/6 is missing the original studs. I tried bolts, but it's hard to get everything lined up properly from under the triple tree top plate, due to limited clearance.
I found some appropriate threaded studs, but I'll need to cut them down to the right length after I install them in the upper part of the clamp.
Can somebody measure the total exposed length of the studs? The studs appear to be two different lengths. I included a stock photo so you'll know what I'm talking about.
Thanks in advance!
I found some appropriate threaded studs, but I'll need to cut them down to the right length after I install them in the upper part of the clamp.
Can somebody measure the total exposed length of the studs? The studs appear to be two different lengths. I included a stock photo so you'll know what I'm talking about.
Thanks in advance!