Results 1 to 3 of 3

Thread: Drilling the Tail Section to Mount Factory Rear Rack

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Drilling the Tail Section to Mount Factory Rear Rack

    Hello! I recently acquired a beautiful '94 K75S with only about 24K miles on it.

    The reason I am writing is to see if I could get some advice on mounting the stock top box on my bike. I have an OEM rack and top box along with all the screws and washers that go with them. I do not have instructions though.

    From what I picked-up off the internet, the rear cowl should be marked on the inside for where the holes need to be drilled (true? If so, what size holes?). I can't believe that the rack simply mounts to the cowl plastic directly. Isn't there some sort of sub-frame that the rack mounts to? If anyone has an old set of directions sitting around or knows the steps, I would be very appreciative!


    Thanks again,
    Mitch
    Last edited by 98lee; 09-05-2018 at 05:15 PM.

Similar Threads

  1. Drilling out Rear Disc Bolts?
    By jconway607 in forum Flying Brick K-bikes
    Replies: 11
    Last Post: 04-25-2015, 03:43 PM
  2. Replies: 6
    Last Post: 09-01-2014, 11:14 AM
  3. Changing the tail section
    By 71243 in forum Oilheads
    Replies: 2
    Last Post: 06-05-2012, 02:27 AM
  4. 85 K100 tail section
    By mtotrainer in forum Flying Brick K-bikes
    Replies: 5
    Last Post: 02-28-2007, 05:25 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •