nevadaslim
New member
I'm rebuilding my front end. After removing the lower sliding tubes, I noticed the holes in the upper standing tubes are at different angles(see photo).
The tube holes on the left are aimed directly to the back. While the holes on the tube to the right are aimed almost but not quite to the front.
My question is, does this mater? is there a correct position for the holes?
Thx...
The tube holes on the left are aimed directly to the back. While the holes on the tube to the right are aimed almost but not quite to the front.
My question is, does this mater? is there a correct position for the holes?
Thx...