Results 1 to 3 of 3

Thread: R1100 Valve cover bolt seals

  1. #1
    Registered User
    Join Date
    Jun 2012
    Location
    Phoenix
    Posts
    35

    R1100 Valve cover bolt seals

    I need to remove the valve cover bolts from a damaged cover.
    How do you get the bolt sleeves/seal....out of the cover?

    Thanks. Ibjman

  2. #2
    I push them out from the inside with a blunt screwdriver. Just work around the bolt until it comes away from the cover, then maybe pull from the outside. Nothing special, no secret.
    Anton Largiader 72724
    Tech articles
    Virginia Motorrad Werkstatt BMW motorcycle service and repair in central Virginia

  3. #3
    Bednarley
    Join Date
    Dec 2010
    Location
    Lake Norman, N.C.
    Posts
    3
    They're tight fitting on the bolt. I just replaced my head gaskets and they had gotten hard...so I ended up using wire cutters to cut them...but I was planning on replacing them anyway. If you're not replacing, it'll be a little tedious ...mine were the originals....
    Chip
    '94 R11RS

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •