txedomoon
New member
Feeling rather inept right now...
Was changing out the battery today and after getting things on the 90/6 back together
I fired the bike up.. idled a bit rough.. I figured it was just cold, etc. and while walking
around the bike I noticed gas flowing freely from the right side carb. I shut thigns down
a.s.a.p.,, turned off the fuel, and it stopped. Thinking I mave have criped the cable
when putting the tank back on I looked to see that the cable was pulling/returning
properly (just eyeballing it) and tried again. Things were fine til I gave the throttle a
light crack -- and the flow returned. I turned everthing off again, cleaned up my mess.
And left it to sit until I can figure out more. My concern right now is that I accidentally loosened
something while taking off the intake hose and it has blocked/plugged/gummed something
up. (Though I tried to make sure the carbs were well protected/covered when doing the work.)
Any suggestions on where to look first?
Was changing out the battery today and after getting things on the 90/6 back together
I fired the bike up.. idled a bit rough.. I figured it was just cold, etc. and while walking
around the bike I noticed gas flowing freely from the right side carb. I shut thigns down
a.s.a.p.,, turned off the fuel, and it stopped. Thinking I mave have criped the cable
when putting the tank back on I looked to see that the cable was pulling/returning
properly (just eyeballing it) and tried again. Things were fine til I gave the throttle a
light crack -- and the flow returned. I turned everthing off again, cleaned up my mess.
And left it to sit until I can figure out more. My concern right now is that I accidentally loosened
something while taking off the intake hose and it has blocked/plugged/gummed something
up. (Though I tried to make sure the carbs were well protected/covered when doing the work.)
Any suggestions on where to look first?