I recently rebuilt the transmission in my R1100RSL. After putting it all back together, trans works great, but I have no turn signals, hazards, no power to the powerlet outlets.
Everything else seems to work fine.
I'm assuming it is a grounding issue, but I cannot find anything showing the various points where the wiring harness grounds to the frame.
(anyone have anything on this?)

I'm really open to suggestions here.....I had the rear end up in the air of course, when the tranny was out. Could possibly be something where the
harness goes into the fuse/electrical box as there was quite a lot of tension on it while in the air.