Still recovering from yesterday...hard work! I didn't take as many pictures as I hoped...I must have been in the "zone".
The first thing was to put assembly lube on the exposed camshaft and then I lubed the new cam followers and slid them into their holes. I put a very thin film of Permatex Ultra Grey on the engine case and on the outboard side of the compression reducing gasket. I made sure there was no buildup of sealant around the top studs. The gasket was 0.66mm thick. I made sure the small o-rings were on the upper studs...they fit into small recesses on the bottom of the cylinders. Here's a not so good picture of the sealant on the case.
The first thing was to put assembly lube on the exposed camshaft and then I lubed the new cam followers and slid them into their holes. I put a very thin film of Permatex Ultra Grey on the engine case and on the outboard side of the compression reducing gasket. I made sure there was no buildup of sealant around the top studs. The gasket was 0.66mm thick. I made sure the small o-rings were on the upper studs...they fit into small recesses on the bottom of the cylinders. Here's a not so good picture of the sealant on the case.