I had a loose left turn lever in the switch assembly. Before spending the money to get a replacement assembly I thought I would see if I could disassemble and fix it. I was able to re-seat the lever in the internal housing but when re-attaching the switch assembly back to the handle bars the lower housing screw would not tighten. Since the screw anchor is the housing I'd have to replace the whole thing which I just fixed. Isn't there someway to fix this?
The assembly seems tight but I can wiggle it a little. The right switch assembly is tight as nails to the bars. I'm going to stop by the local dealer to see if the other R12R bikes left switch assembly is as secure as mine is now. Maybe its normal and I should just forget about it. I just hate to have something that isn't quite right and could loosen some day when I'm 1000 miles from home.