Results 1 to 5 of 5

Thread: 07 1200RT Front Turn Signal Installation

  1. #1
    Registered User
    Join Date
    Jan 2008
    Location
    Stow, OH
    Posts
    28

    07 1200RT Front Turn Signal Installation

    I am trying to install a complete front right turn signal after removing the original
    (in pieces - easy). Does the entire upper front end, including windshield, headlights, dash, etc., have to be removed for installation?
    Thanks!

  2. #2
    Registered User lkchris's Avatar
    Join Date
    Mar 2003
    Location
    Albuquerque, NM
    Posts
    6,285
    Of course not.
    Kent Christensen
    21482
    '12 R1200RT, '02 R1100S, '84 R80G/S

  3. #3
    Registered User
    Join Date
    Jan 2008
    Location
    Stow, OH
    Posts
    28
    Kent,
    That's great news but how do you install it?
    Thanks!

  4. #4
    Rally Rat
    Join Date
    Aug 2005
    Location
    NE Ohio
    Posts
    452
    Remove the mirror and top trim. Should expose enough to figure out what to remove/replace.

    Or I can stop by and show you what needs to be removed as I'm not that far from you to the North.

  5. #5
    Registered User natrab's Avatar
    Join Date
    Sep 2012
    Location
    Antioch, CA
    Posts
    359
    Start by taking off the dash part with the speaker covers, the windshield and side mirror covers. If you unscrew the front fairing and bring it forward just a little bit (i disconnected the headlight wiring harnass just in case) you can get to the two screws that hold in the turn signal housings.

    See this thread:

    http://forums.bmwmoa.org/showthread.php?t=31084

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •