C
cryoteck
Guest
I've just finished my clutch job on my R1150RT, and after taking a small ride to confirm everything ok, when I put the bike on the center stand, I rotated the rear wheel by hand in Neutral and found that there is some play before it makes contact with the shaft (?).
Kinda hard to explain but let say I spin the wheel one way in takes like 2 inch of rotation before I feel the shaft moving, and again when I rotate the other way.
Now maybe this is perfectly normal, but since i've just did this clutch job (which is worse looking than it seems) I just want to make sure there's not a problem with the inside of my rear drive.
Thanks to anyone with confirmation that this is ok or not!
YvanD
Kinda hard to explain but let say I spin the wheel one way in takes like 2 inch of rotation before I feel the shaft moving, and again when I rotate the other way.
Now maybe this is perfectly normal, but since i've just did this clutch job (which is worse looking than it seems) I just want to make sure there's not a problem with the inside of my rear drive.
Thanks to anyone with confirmation that this is ok or not!
YvanD