Olsensan
New member
I have seen posts where a seal was knocked on one side to cock it over for removal. Has anyone done this with the slave seal inside the slave cyl cavity? I have the entire unit heated up to 100 degrees and although the seal is pliable, it will not budge. Any ideas, I'm beat right now.
Update, finally have it removed. Apparently some sort of gasket sealer or adhesive was used on the outer walls of the seal and it was really stuck tight. I had to wrap it pretty hard to free it up and get it cocked on one end. Drilled a hole in the opposite end and pulled it with a screw imbedded. I'm trying to figure a way to remove the substantial amount of adhesive from the walls of the slave cyl. cavity where the seal rests. I would not have expected that this would be done at the factory. Oh well. Any good ideas out there for solvent for the adhesive? .
Update, finally have it removed. Apparently some sort of gasket sealer or adhesive was used on the outer walls of the seal and it was really stuck tight. I had to wrap it pretty hard to free it up and get it cocked on one end. Drilled a hole in the opposite end and pulled it with a screw imbedded. I'm trying to figure a way to remove the substantial amount of adhesive from the walls of the slave cyl. cavity where the seal rests. I would not have expected that this would be done at the factory. Oh well. Any good ideas out there for solvent for the adhesive? .
Attachments
Last edited: