Results 1 to 2 of 2

Thread: LED tail/brake light R1100S

  1. #1
    Registered User
    Join Date
    Jul 2007
    Location
    Carol Stream, IL
    Posts
    73

    LED tail/brake light R1100S

    Question for anyone regarding the R1100S. Would like to add an LED brake light to the rear license plate bracket, but it looks like to only way to route the wires would be up through the silencers. The license plate light wire is routed this way but seems to have a shielded wire or wires as protection from the heat. Any suggestions on either an alternate way of routing the new wiring, or where to get shielding or shielded wires to do the job?

  2. #2
    not so retired henzilla's Avatar
    Join Date
    Sep 2006
    Location
    CENTEX USA
    Posts
    10,945
    have done this on our 11S...bought additional high heat resistant jacket from the local auto parts...it is pretty pricey, some may sell you the short piece you will use instead of the whole roll. Trying to snake it under/between the pipes and thru that grommet takes patience. Had to take a lot of the rear fender,lights assy off I recall to sanely get the wires thru.

    We had an aftermarket license bracket that was on the bike and it broke shortly after..it did not like ANY additional weight. We had the Run-N-Lites 3 LED frame which is a little bulky...was for that particular frame anyways...works on several other of our bikes with no isssues.
    Steve Henson-Mod Team and past prez SABMWRA

    Be decisive, right or wrong.The road of life is paved with
    flat squirrels who couldn't make a decision~unknown

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •