Results 1 to 15 of 37

Thread: Gerbing Permanent Controller Install DIY

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #31
    Honey Badger Semper_Fi's Avatar
    Join Date
    Aug 2008
    Kingston, NH
    There is no science to the next part - to align the hole drilling for the LED, I used a straight edge and I aligned it with the + cross-hair (yellow arrow) of where to drill the shaft hole and then drew the line.

    Then I got on the bike to see if it was lined up - it wasn't - so I drew the corrected one you see below and proceeded to drill the hole.
    Attached Images Attached Images
    Last edited by Semper_Fi; 03-13-2010 at 04:41 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts