.jpg)
As the trigger wire is black and there is still more wiring do to, I quickly threw on some white heat shrink tubing for identification and noted the end.
I will shrink the tubing later once the final length is established
As the trigger wire is black and there is still more wiring do to, I quickly threw on some white heat shrink tubing for identification and noted the end.
I will shrink the tubing later once the final length is established
Last edited by Semper_Fi; 02-08-2010 at 02:00 AM.
The relay shown with the arrow is not OEM equipment it is the relay for my Centech
The green highlight is where I am mounting the relay for the horn.
Tools used are a T30 torx and a 10mm wrench
Last edited by Semper_Fi; 02-08-2010 at 02:01 AM.
Detail of relay mounted.
Note 1 - the hole where the bolt goes thru is a little small, you will need to run the bolt thru to ensure it fits
Note 2 - the bolt is intentionally mounted upside down (by me) this is to provide the surface area of the washer on the tab of the relay
Last edited by Semper_Fi; 02-08-2010 at 02:02 AM.
Detail of the nut mounting below the relay
Relay connection points
I decided to create my own power harness as I did not want to use black as a power wire
Connecting the power for the horn from the Centech
Last edited by Semper_Fi; 02-08-2010 at 02:04 AM.
This special connector provided in the kit, connects the grounds of the compressor and the bike (from Centech) together
Grounds connected
The relay is connected
Please note at the time the length of the control wire (horn) was known i shrunk the white tubing
2011 R1200 GSA Smoke Grey Metallic Matt
2009 G450X White
IBA #35651
Rogue Moderator
Mount Horn under the ABS controller as shown with the zip ties provided
Rear zip tie is a litte tricky to get in - detail provided below
All wire harnesses dressed and the product tested.
It is QUITE LOUD!!
Last edited by Semper_Fi; 02-08-2010 at 02:05 AM.
While helping out a friend do his Stebel install he routed the air horn hose differently from the instructions and it seemed a more natural postion for the hose to follow instead of the instructed one.
Shown below is the alternate routing.
Up to you which you want to use.
Last edited by Semper_Fi; 03-06-2010 at 01:18 PM. Reason: Updated with alternate Hose Routing suggestion
At this point you can put the plastic back on, kick back and have an adult beverage
2011 R1200 GSA Smoke Grey Metallic Matt
2009 G450X White
IBA #35651
Rogue Moderator
Posting Permissions
