• Welcome, Guest! We hope you enjoy the excellent technical knowledge, event information and discussions that the BMW MOA forum provides. Some forum content will be hidden from you if you remain logged out. If you want to view all content, please click the 'Log in' button above and enter your BMW MOA username and password.

    If you are not an MOA member, why not take the time to join the club, so you can enjoy posting on the forum, the BMW Owners News magazine, and all of the discounts and benefits the BMW MOA offers?

KGT Spline Lube

Secure wire harness ring to the 3 o'clock position on the drive.

The spec for the screw (T-25) is 4 Nm (2.95 ft/lbs) and I do it hand tight
 

Attachments

  • 54_SSW_Clip.jpg
    54_SSW_Clip.jpg
    95.1 KB · Views: 410
Last edited:
The final routing for the speed sensor harness is on the bottom of the driveshaft tunnel as shown.
 

Attachments

  • 55_SS_DS.jpg
    55_SS_DS.jpg
    64.7 KB · Views: 407
At this point the remaining assembly items are listed below for re-installation:

- caliper

- the final routing of the speed sensor wire on the rear brake line

- mounting the rear wheel

- installing the muffler

These steps can be picked up in this link

Link For Reassembly
 
Last edited:
Back
Top