Windshield/Nose/Headlight Trim Removal KGT1300

[Semper_Fi]

Rotate mirrors up to access screws

[Semper_Fi]

Using a T-30 remove the screws highlighted.

[Semper_Fi]

Remove the turn signals - note you will need to disconnect electrical connection.

Use #1 Philips

[Semper_Fi]

Pull of turn signal and disconnect electrical connection - repeat for other side.

[Semper_Fi]

At this point the only thing left is 6 T-25 torx holding the headlight trim on.

4 up front one is in the turn signal area the other by the windshield

2 behind the oil cooler opening

2 on each side - NOTE - Remove these last and support the headlight plastic on the last one

**********************************************

The 2 by the Turn Signal and Windshield area - Shown is Throttle side

[Semper_Fi]

The 2 by the Turn Signal and Windshield area - Shown is the Clutch Side

[Semper_Fi]

The two by the Oil Cooler

[Semper_Fi]

The last two on the sides

NOTE - support the headlight plastic when removing the last screw

Throttle side shown

[Semper_Fi]

The last two on the sides

NOTE - support the headlight plastic when removing the last screw

Clutch side shown

[Semper_Fi]

Your work is complete.

Bike is shown with all the plastic removed.