Hi guys and girls. I’m sure that quite a few of you have had your bikes go into limp mode. The confusing thing for me is that after my bike went into limp mode but. thing came back to life withing a couple of hundred metres.
I took it for it’s service the next week and it did not show any ERROR with what had happened when plugged in.
Has anyone had this happen and did it throw up an Error code with your workshop? It has only happed once in 500klms. My bikes doe 16,400klms so far with not other worries. (10,190 miles)
On a side note the dealer lent me a F900R to use while my bike was in the workshop for about 4 hours. What a hoot, super lite and it felt tiny.
Bruce from Wagga Wagga Australia
I took it for it’s service the next week and it did not show any ERROR with what had happened when plugged in.
Has anyone had this happen and did it throw up an Error code with your workshop? It has only happed once in 500klms. My bikes doe 16,400klms so far with not other worries. (10,190 miles)
On a side note the dealer lent me a F900R to use while my bike was in the workshop for about 4 hours. What a hoot, super lite and it felt tiny.
Bruce from Wagga Wagga Australia